Shopbot control software

Perform the test and the tester will display a percentage. The percentage should be 75 or greater. If these tests result in a poor communication speed, replace the cable connecting the PC to the tool.

Need additional information? Let us know. Share this answer:. Outside of normal office hours, we regularly check for support requests, email and phone messages. To make sure we can get back to you as soon as possible, leave a phone number or return email address where you will be available. Get in touch! Toggle navigation. My ZZero plate is not working Where can I find the 3 axis zero plate files?

What maintenance is required for my Becker vacuum pump? How do I choose a bit? What Feeds and Speeds should I use? Accessories:Control Computer. How do I set up my control computer? I installed the ShopBot software, but the drivers did not install. How do I install the drivers? How do I get it to find the port? I need to replace my Porter Cable Desktops DT24x This is the new stuff under the hood! Outside of normal office hours, we regularly check for support requests, email and phone messages.

To make sure we can get back to you as soon as possible, leave a phone number or return email address where you will be available. Get in touch! Toggle navigation. ShopBot Control Software. Fill out my online form. This should resolve - An alternate implementation of this version of software that uses slowed USB speeds for computers that are experiencing USB communications issues; called 3. Version 3. You need to re-input older locations for this fuctionality to take effect.

The assumption being that you could not run the routine if you weren't above the plate. The pull-up still occurs after each touch-off on the plate. Use [VC] to reduce the Safe-A pull-up if you do not want to pull up as high. The default value is 1. See examples in Programming Handbook. If you have a tool with a Z-prox use Setup under Tools to configure it to be able to re-position the cutter that was last Z-Zeroed.

Also works for G20 and G21 the G-code verison Version 3. These are dependent on hardware components that are not included on the early cards. Independent Indexer Spinner or Axis Oscillator [Available via the MI Command] 12 Outputs [additional 4 only directly accessible on newer Control Boards; available on all boards via a header connector on Control Card though user will need to provide isolation] 12 Inputs [additional 4 only directly accessible on newer Control Boards; available on older boards only with modification; on Desktops only will be available; user will need to provide isolation for direct inputs ] PWM System for controlling a laser cutter Heater control functions for 3D printer [extruder motor controlled by B Axis] 2 channels of analogue input measurement capability v DC 2 channels of analog output capability v DC; low mA Control Card temperature measurement [reported in UD] Logic power line voltage measurement and spiking [reported in UD] as well as communications performance information New Control Software and UI Features.

Note that Rhino does not export any CNC cutting files. More details. Outside of normal office hours, we regularly check for support requests, email and phone messages. To make sure we can get back to you as soon as possible, leave a phone number or return email address where you will be available.

Click here to download your Quote. Get in touch! Toggle navigation. Design Software To make you quickly productive with your ShopBot, we provide powerful design software with every tool. Learn More about Vcarve Pro. ShopBot Tools, Inc. All rights reserved. Terms of Service ShopBot Tools Warranty All information is correct to the best of our knowledge but prices, descriptions, and typos may change without warning.